10
4. Description of the controller operation
After switching on the power supply of the controller, it is immediately ready for operation. When
any button on a programmed remote control is pressed or a control input is triggered, the corresponding
controller function will be performed. In the operating mode, the current state is indicated by the signaling
output and LED diodes. Immediately after powering up the controller, the first move will be to
open
.
4.1. Synchronization of the gate leaves
When one of the actuators meets an obstacle that prevents its further movement, the other one
does not stop. In this case, there is a possibility of the gate leaves getting out of sync, which may be
important when the sequence of closing the gate leaves is important (one of the leaves has an overlap).
Then it becomes necessary to re-synchronize the gate leaves, which should be done as follows:
·
trigger the OPEN movement,
·
wait until both leaves are fully opened (it may be necessary to first call the CLOSE direction and
then OPEN direction).
5. Programming the BLUE 232 controller
The BLUE 232 controller is programmed to the needs of a given installation using a dedicated
Blue Motor Control application for Android devices, communicating with the controller via Bluetooth ™.
The
Blue Motor Control
app is available for download from the GooglePlay store.
In order to efficiently carry out the controller programming process, the following sequence
should be observed:
- analyze the needs in relation to the functionality of the controller;
- establish communication between the controller and the application, see section 5.2;
- start Autolearn in the Blue Motor Control application;
- conduct learning by following the messages in the application;
- check the operation of the automation and possibly make additional changes and adjustments via the
application.