3
Unidirectional
dinghy
Fwd
(Airplane,
). Stop: =<1,2ms.
>1,2ms.
Example .
2
RAMP 5 LED
. Connect LED E5 with R1 resistor to RAMP 4.
Example 1.
RAMP 4 LED
.
Power 2S Li-Pol (2 x 3,7 = 7,4V).
OPERATION
Control:
Stick / Wheel / Switch Position 2P / 3P Switch.
OPTIONAL SETTINGS
for RAMP 4 and 5 LED: 7,4 - 0,6 - (2 x 3,2) =
0,4
(OK)
Calculation
„-”
no function, no light.
Insert jumper F1 through F6 into connector K3 to set the DL4B function.
Connect the control cable to the switched on receiver. When the
power is connected, LED L2 indicates the selected function by the
number of flashes (The K3 status is read only when it is switched on).
Signal loss: LEDs L2 to L4 are off.
LED Powering from Driver Battery
(4 - 24V). Connect LED anodes to
positive (+) battery pole. The maximum number of connected LEDs is
determined by the battery voltage per formula:
Uaku -0,6-(n x Uled).
Uaku= battery voltage, 0,6V=stabilization, n=number of LEDs,
Uled=LED voltage. The calculated value must be between
0 - 5
(otherwise its overloaded).
Connect in parallel two 2x 3.2V LEDs in series.
E1, E2
Connect LED
anodes to positive (+) battery pole.
Connect the LEDs E3, 4 to pin L (L1
to L4). Do not connect LED E5 and resistor R1.
Range throttle.
(car, boat, TIR).
: <1,5ms. Neutral:
Reversible
Bwd
1,5ms.
>1,5ms.
Fwd
L4
-
-
lights
L2
-
-
lights
Functions with F1 jumper:
Stick
Bwd
Neutral
Fwd
L3
-
-
lights
lights constantly
L1
lights constantly
L1
Stick
Bwd
Neutral
Fwd
L2
-
lights
lights
Functions with F2 jumper:
L4
blinking
blinking blinking
L3
-
-
lights
R1 220R
L4
E1, 2
E3, 4
E5
GND
-
+
Battery
drive
