LED polarity:
flat side (usually shorter lead)
is negative (
C
athode).
When the voltage drops under 5V the LEDs light intensity decrease.
Car / Boat / Plane / BUS
, TIR, Tractor, Tank, Dinghy, Sub, Glider.
W
- resistant to splashing water, snow, humidity and dust.
in parallel, Connect 120R in parallel to one 2V
LED (current is divided into 20 + 20mA).
WIRING
Each pin L1-L4 maintains a current of 40mA. By parallel connection of
LEDs the current is divided into 20 + 20mA. You can connect only the
same LED types in parallel. If you connect one 3V LED to any L1 - L4
pin, then connect R1 150R resistor
Powering LEDs from the Receiver (4 - 8V).
Connect the LEDs
cathodes to L1-L4 connector pins. Connect the LED’s anodes to +L.
When using 2V LEDs (red), you can connect two parallel connected
LEDs or 2x two parallel connected LEDs in series.
Plug the control cable to the receiver (channel ESC, servo or free). Plug
the servo cable in to connector K2, which is connected to the control
cable. Vývody LED zkraťte na délku 5mm. Solder the wires to
connector’s counterparts. Cut the LEDs lead to 5mm length, extend
the leads with wires and isolate them properly.
2
DL4B
DL4BW
RC Models
+A
-C
+A
-C
R1
Lx
Universal RC
LED Lighting
Boat.
L1: Mast, L2: front, L3: cabin, L4: rear
LED application examples
Aeroplane
. L1: reflector, L2: landing, L3: beacon, L4: position
Car.
L1: reflector, L2: front, L3: inner, L4: rear
Connector K2
Connector K3
(Set)
Connector K1
Jumper
F1-F6
Control
cable
+L
L1
L2
L3
L4
SET
DL4B
K101
RC
receiver
L1
L2
L3
L4
+L Power LED
(anode)
right
/ left
right
/ left
right
/ left
right
/ left
F1
5V
G