ISOSTEM USER MANUAL
30 GUI Software Reference
Rear Mute/Solo
These buttons are used to mute or solo the Rear fader signal.
Rear Step Gain
This read-only display shows the gain setting for the rear channels selected
in the multifunctional area's "Misc" tab (see
Unit: dB
Rear C-out
This fader controls the level used to inject the phase-reverted discrete Cen-
ter signal output of the Panoramic Analyzer into the output busses LS and
RS.
This parameter is used to fine-tune the presence of the phantom source
between the LS and RS rear channels. Higher fader positions increase the
removal of Center signal components from the LS and RS rear channels.
Please note:
This function depends on the position of the "Rear" fader (see
above). It is also controlled by the Rear Mute and Solo buttons.
Unit: dB
Range: 0 dB - -inf
Rear S-out
This fader controls the level used to inject the phase-reverted discrete L
and R front signal outputs of the Panoramic Analyzer into the output busses
LS and RS.
This parameter is used to fine-tune the diffuse signal components of the
front channels L and R in relation to the direct sound in the LS and RS rear
channels.
Unit: dB
Range: 0 dB - -inf
Please note:
This function depends on the position of the "Rear" fader (see
above). It is also controlled by the Rear Mute and Solo buttons.
Please note:
For in-depth signal flow details, please also refer to the block
diagram in
