dSPACE DS1103, Hardware Installation And Configuration Manual

Page: 34 / 302

Setting up the DS1103
Before inserting the DS1103 in the host PC or in the expansion box,
you have to check if the default factory setting of the I/O base
address (port address) must be changed.
Objective
Information in this section
Basics on Changing I/O Base Addresses
For several conditions you have to change the default I/O base addresses
(port addresses) of dSPACE boards. This is to avoid conflicts with other
devices within your system.
34
How to Change I/O Base Addresses
35
Basics on Changing I/O Base Addresses
For several conditions you have to change the default I/O base
addresses (port addresses) of dSPACE boards. This is to avoid conflicts
with other devices within your system.
Objective
Note the following hints on changing the default I/O base address.
NOTICE
Assigning I/O addresses already used by other
devices may lead to system failure, data loss on the
hard disk, and even hardware damage.
n
Refer to your PC’s technical reference manual for a
description of the standard I/O map and to the
documentation of additional I/O boards that might be
inserted in the PC.
n
Refer also to the lists of resources used in the diagnostic
utilities of the PC’s operating system. However, these
are not always complete.
Notes and Hints
Where to go from here
s
Installing the Hardware
t
34
s
DS1103 Hardware Installation and Configuration November 2014