dSPACE DS1103, Hardware Installation And Configuration Manual

Page: 22 / 302

For purposes of rapid control prototyping (RCP), specific interface
connectors and connector panels provide easy access to all input and
output signals of the board.
Using an
adapter cable you can link your external signals from the
100-pin I/O connector on the board to Sub-D connectors. So you can
make a high-density connection between the board and the devices
of your application via Sub-D connectors.
Specific interface
connector panels provide easy access to all the input
and output signals of the DS1103 PPC Controller Board:
n
The CP1103 C onnector P anel provides easy-to-use connections
between the DS1103 PPC Controller Board and devices to be
connected to it. Devices can be individually connected,
disconnected or interchanged without soldering via BNC
connectors and Sub-D connectors. This simplifies system
construction, testing and troubleshooting.
n
In addition to the CP1103, the CLP1103
C
onnector/
L
ED Combi
P anel provides an array of LEDs indicating the states of the digital
signals.
Easy access to input and
output signals
To demonstrate control design and implementation, demo equipment
(VCFP Simulator) is available for the DS1103.
Demo equipment
The DS1103 PPC Controller Board is a single-board system. The
package contains one board with a triple bracket and adapter cables
with six Sub-D connectors.
If you ordered the DS1103 together with an expansion box, the board
is not installed in the box.
To avoid damage to the hardware during transportation,
the DS1103 PPC Controller Board is delivered separately
and has to be installed in the expansion box.
Shipment
Software
The dSPACE software, such as the implementation and the
experiment software, comes on DVD and has to be installed first. For
further information, refer to
Introduction to dSPACE Software
Products on DVD ( Software Installation and Management Guide ).
Objective
s
Introduction to the DS1103
t
22
s
DS1103 Hardware Installation and Configuration November 2014