[228] Voice Call Back Time
Default (0A) Valid entries are 00 - FF.
[229] Voice Call Back Number
Default ( ) 32 digit phone number.
SMS Event Notification/Command and Control Options
When an event is triggered by the panel and SMS notification is ON in section [301] toggle option [1], an
SMS message is created and sent to the SMS telephone numbers programmed in sections [311]- [342]
for event types specified in sections [343]- [374] if toggle [7] is ON. The system will make one attempt to
send the SMS message to each of the programed telephone numbers, starting with the first number. If it
is unsuccessful, the SMS message will be sent to each of the remaining numbers, in sequence, until suc-
cessful or all numbers are used.
The SMS send message is formatted in five parts as follows:
Account Label [351], Date and Time [DD/MM/YY HH:MM], Partition Label programmed in panel, Event
Label [451]-[596], and User Label programmed in panel (or Zone Label programmed in panel).
Extra spaces in each of the five parts of the message are removed when the SMS message is composed.
If the message is too long, all extra characters are removed and will not be included in the SMS message.
NOTE:
If a panel event occurs during an SMS transmission, the unsent SMS messages are delayed until
the new event is transmitted.
NOTE:
It may take up to four minutes from communicator power-up to synchronize the SMS time stamp
with panel time.
[301] Command and Control Toggle Options
[1] SMS Notification
Default (ON)
[2] Serial Communication Port Enabled
Default (OFF)
[3] SMS Command and Control
Default (ON)
[4] Interactive
Default (OFF)
[5] SMS Character Format
Default (OFF )
ON:
SMS Unicode, maximum message length is 70 characters.
OFF:
7 bit SMS, maximum message length is 160 characters.
[6] Long SMS Message Handling
Default (OFF)
ON:
If longer than maximum message length, it is split and sent as multiple SMS messages.
OFF:
If longer than maximum message length. A single, truncated SMS message is sent.
[7]Reserved
[8]Reserved
[307] SMS Delimiter
Default () Valid entries are 00 - FF.
[308] Outgoing SMS Retry Attempts
Default (19) Valid entries are 00 - FF.
The default value is 25 attempts. If the communicator is having difficulty delivering an SMS message, it
shall send the message again up until the number of retry attempts has been met.
[309] Outgoing SMS Retry Counter
Default (0005) Valid entries are 0000 - FFFF.
If the communicator is unable to deliver an SMS message, it will wait the number of seconds pro-
grammed in this section before attempting to resend the message.
[311]-[342] SMS Phone Number 1-32
Default ( )
These sections may be programmed through DLS or the keypad. Up to 32 SMS telephone numbers (4-
32 digits) can be programmed in sections [311]-[342]. Leaving programming blank for a telephone num-
ber will disable that number. The user can program their own mobile telephone numbers at the keypad
using [*] [6] < > “SMS Programming”. The SMS command and control feature uses the SMS messaging
service provided by the cellular network and is subject to the limitations of SMS messaging. These lim-
itations include delayed messages and lack of guaranteed delivery.
NOTE:
SMS command and control (sections [601] -[618] will only process messages from mobile tele-
phone numbers programmed in this section if SMS command and control is enabled [301][3] ON.
SMS responses are listed in sections [621]-[630]. A blank telephone number is disabled.
[343]-[374] SMS Phone Number 1-32 Toggle Options
The toggles in this section determine the type of event message that will be sent to the SMS number pro-
grammed in sections [311]-[342].
[1] SMS Notification Alarm/Restore
Default (ON)
29
