DSC GS3100-BX Manual Download Page 21

Page: 21 / 76

GS3125/GS3105

Receiver 2, Local Port 2 and Alarm Port 2 IP address

This check box is used to enter the second IP address for the receiver and the port number, with the difference that these parameters are
considered as a backup receiver. The Communicator only recognises this box if the parameters corresponding to the

Main Receiver

Local Port 1

and

Alarm Port 1

address have been entered. Furthermore, the

Enable Supervision

and

Supervision time

boxes

refer only to the primary receiver.

APN1 Username and Password, APN2 Username and Password

Some providers may require a user name and password to validate communication. If needed, enter this information here.

APN2

Username

and

Password

are considered to be backup data.

Telephone numbers to decode

This communicator permits to communicates the events in the Contact ID format, via the GPRS network, also to the control panels that non
support this communication method.
To do this, you must setup a “virtual” telephone number on the control panel for event communication in Contact ID format (e.g. you can
setup 0123), then you must enter the same virtual telephone number in one of this fields (you can setup up to four "Virtual" Telephone
Number for this function).
When the Communicator recognises a call from one of these numbers, automatically transcode the event in digital format and forward it on
the GPRS network to the set receiver (refer to the “Main Receiver” and “Backup Receiver” options).



The “virtual” telephone number must be of at least 2 digits.
The options “Prefix” and “Digits to Remove” have no effect on the “Telephone numbers to decode”.
The “Telephone numbers to decode” must exactly match with the “Virtual” telephone numbers set for the control panel.
Leave this fields empty if you don't use this function.
You must setup the “Main Receiver” and “Backup Receiver” options for proper working of this function.

DNIS

If required, enter the Dialled Number Identification Service number.

Account code

The account code for communication with SYSTEM III or SYSTEM II receivers must be entered in this box.

Enable Supervision

To enable supervision, select this option. The supervision option is ONLY available to the main receiver. The supervision messages are
not sent when the device is performing a voice call (on GSM).

Supervision time (sec)

Set the Supervision time for the monitored zones. It is possible to set a Supervision time between a minimum of 5 second and a maximum
of 65535 seconds, with steps of 1 second.

Web Service (GS3125 series only)

The

Web Service

is an interface which can be used to access, via the network, the features offered by the GS3100 Series Console

software application. The transmitter parameters can be managed remotely using this interface. To use this function, visit the web address
http://www.dscreachme.com.



Enabled

: To enable the Web Service, click this check box to enter a tick



(this setting is enable by default).



Encryption key

: The encryption key can be set so that the Web service cannot be accessed by unauthorised persons. The encryption key

may include between 1 and 32 hexadecimal characters. The default setting is 0 (encryption key not enabled).