DSC GS3100-BX, Manual, Page: 20 / 76

20
GSM/GPRS Alarm Communicators
System (GS3125 series only)
This section refers to the System.
 SIM Phone Number : Enter the telephone number of the Communicator’s SIM CARD (maximum 16 digits).

Auto Clock Adjusting : Checking this option the device will update the system date and time by sending an SMS itself.
 SMS Service Center Address : This is a read-only option. It shows the number of the SMS services centre on the SIM CARD.
Pay As You Go (GS3125 series only)
 
 

The pre-paid SIM CARD credit management service may be suspended at any time, at the discretion of each individual
GSM network operator.
This section can be used to send an SMS providing credit balance information (supplied by the operator) to the first number in the
phonebook at regular intervals. Program the following options for a correct credit balance check request, in accordance with the type of
operator used:

Enquiry Type : selection of enquiry type (SMS, Call, Service Command).
 Enquiry Number : telephone number to call or to which an SMS message should be sent in order to request credit balance information.

Balance Message : string used to send SMS messages and to make requests via service commands.
Example for Italian operators
Options Vodafone Wind TIM
Enquiry Type Call Service Command SMS
Enquiry Number 404 40916
Balance Message *123# PRE CRE SIN
 Interval : Enter the interval (HH-DD) at which you wish to send a perodic SMS containing credit balance information (if supported by
your telephone operator). The interval consists of the following values:
— (HH) next message time - Select the time at which you wish to send the next periodic SMS. The interval for these values may be
set between 0 and 23.
—- (DD) next message day - Select the day on which you wish to send the next periodic SMS. The interval for these values may be
set between 0 and 365.
Outputs(GS3105 series only)
This section may be used to set the operating modes of the outputs.
 Output 1 , Output 2 , Output 3 : Check the box for output operation normally closed or normally open .
 Output 3 ON Time : The ON time in seconds may be entered in this field (between 0 and 86400 seconds).
Primary Path
The user can program the primary communication line.
 Primary Path: Select the primary GSM or PSTN line using this field.
GPRS
This page outlines the GPRS configuration options.
 
 

Bearing in mind the delays which may occur in transmission via GPRS, which are caused by the activities of the network
manager, we recommend you program as many call attempts to the burglar alarm control panel as possible, and that you also
provide a backup telephone number which transmits alarms via GSM as well as via GPRS.
Access Point Name 1 and Acces Point Name 2
Enter the Access Point Name of the GPRS service provider being used. Enter the name of the IP address service provider in this box.
Access Point Name 2 is considered a backup parameter.
Main Receiver, Local Port 1 and Alarm Port 1 IP address
Enter the primary receiver IP addresses and port numbers. For Sur-Gard SYSTEM III and SYSTEM II enter the IP address and the port
listed in the
Alarm Port section.