5
Jumper JP3
JP3 ON
- Full power, including standby capacity, comes from the host panel or external power
supply. Supply must be capable of up to 500mA (plus 200mA maximum from AUX+). The 3G3070
battery must
not
be connected.
JP3 OFF
- Current limiting mode, the host panel or external supply provides standby current. Supply
must be capable of 120mA plus any current drawn from AUX+ terminal. 3G3070 battery must be
installed for proper operation.
Status LEDs
NOTE: The power supply must have a minimum voltage of 13.5V to ensure a sufficient battery
charge.
NOTE: When disposing of batteries, follow the instructions and precautions printed on the bat-
teries, and contact your municipal offices for information on the disposal of used batteries.
The 3G3070 interface has four status LEDs. The following describes the control panel status LEDs.
NOTE: The top two LEDs blink during the Initializing and Programming phases.
RED
- This LED is normally off; but, it will flash in the event of a trouble. This LED will switch on
within three minutes in the event of wireless Module [figure 1, item 16] trouble, or when the wireless
Network is unavailable, ‘No Service’. If this LED flashes, the following list indicates the specific trouble
based on the number of flashes, by priority. When turned on, the 3G3070 checks for the trouble
conditions to be restored in the order listed below. The 3G3070 indicates the status of the highest
priority, unrestored trouble condition with the corresponding number of flashes of the red LED. Once
the highest priority trouble condition has been cleared, the next highest priority trouble condition is
displayed (if applicable).
1 flash
- Battery Trouble (battery with low voltage output)
2 flashes
- Radio/SIM Trouble (battery absent or SIM Card disconnected)
3 flashes
- Wireless Network Problem (SIM not active, poor signal strength, antenna not connected)
4 flashes
- Insufficient Signal Strength (poor location)
6 flashes
- Receiver not available (improper programming, receiver absent)
7 flashes
- Power Supply Trouble (DC power supply absent)
8 flashes
- Supervising receiver trouble
Off
- No Troubles
YELLOW
- When this LED is on (solid), a Phone Line Trouble condition exists. This LED switches
on when the interface switches to the Wireless Network (due to a landline trouble condition). This
LED will also flash once to indicate a signal transmission and twice to indicate an acknowledg-
ment from the receiver
GREEN (Top)
- When this LED is on, the reception is optimal. This LED switches on only when the
other Green LED is on.
GREEN (Bottom)
- If this LED is off and the Red LED is on, the Wireless Network service is
unavailable (NO SERVICE). This LED flashes when the Wireless Network reception is poor. If this
LED is on, the 3G3070 is able to communicate with the 3G (HSPA) or 2G (EDGE/GPRS) network.
NOTE: It is recommended that the device have at least one of the green LEDs ON (solid) for the
location to be considered acceptable.
Summary of Contents for 3G3070
Page 2: ......
