9
Events description
Customer Code
- type in a 4 character code (accepted values: digits and the letters A, B, C, D, E and F).
Event Code
- type in the Contact ID to be transmitted when the respective event occurs.
Send
- select (tick) the events to be sent.
See the ‘Operating Principles’ section of this manual for default contact ID events.
Contact ID Default
Click on this button to assign the following event codes to the events managed by this device.
Event Description
Event Code
Central Station Description
Input 1 Activation
E 110
Fire Zone 001
Input 1 Restoral
R 110
Fire Zone 001
Input 2 Activation
E 120
Panic Alarm Zone 002
Input 2 Restoral
R 120
Panic Alarm Zone 002
Input 3 Activation
E 130
Burglary Zone 003
Input 3 Restoral
R 130
Burglary Zone 003
Input 4 Activation
E 150
24 Hour Zone 004
Input 4 Restoral
R 150
24 Hour Zone 004
PSTN Line Down
E 351
Telco 1 Fault 000
PSTN Line Restoral
R 351
Telco 1 Fault 000
12V Input Loss
E 337
Exp. Mod. DC Loss 000
12V Input Restoral
R 337
Exp. Mod. DC Loss 000
Low Battery Alert
E 338
Exp. Mod. Low Bat 000
Low Battery Restoral
R 338
Exp. Mod. Low Bat 000
Periodic Report
E 603
Periodic RF Xmission 000
Cellular Unit Activation
R 552
Radio Xmitter Disabled 000
Cellular Internal Buffer Full
E 624
Event Log Overflow 000
FTC Event
E 354
Failure To Communicate 000
FTC Restoral
R 354
Failure To Communicate 000
Send over Cellular
If this option is enabled, this device will only communicate via cellular network, effectively putting the
communicator into primary mode. If this option is disabled, the communicator will operate in back-up
mode.
Periodic Reports
This device can be programmed to send periodic Contact ID reports. This section will allows the selection
of the
Date
and
Time
of the first periodic report and the
Interval
between reports.
Note: If the external power supply (connected to terminals [+12v]) and battery power supply drop
at the same time, the device must be re-programmed after the power supply is restored, other-
wise the time set for the Periodic Report cannot be respected.
Cellular page
This page outlines the cellular configuration options.
Access Point Name (APN)
Enter the Access Point Name of the cellular service provider being used (example: ibox.tim.it). Please
contact the Cellular service provider for this information.
Receiver IP address and Port
Enter the primary (mandatory) and back-up (optional) receiver IP addresses and port numbers. Use the
same IP address and port that is found in the 'Receiver Remote Port' section of the receiver.
APNs User Name and Password
Some providers may require a user name and password to validate communication. If needed, enter this
information here.
DNIS
If required, enter the Dialed Number Identification Service number. This should be the same DNIS
Summary of Contents for 3G3070
Page 2: ......
