Dru 0063CT3681, Installation Manual

Page: 30 / 48

I nst allation manual
3 0
The flame picture can be affected by moving the vermiculite.
3
- The vermiculite should not get higher than the edge of the burner.
- The burner deck does have to remain covered with vermiculite, so that the life span of the burner is not reduced.
1
Identify logs A to F (see fig. 8-6).
2
- Use the burn stains on the logs for identification.
- Logs E and F are not the same.
1
Place log A over the lying burner in the positioning cams, the log should not cover the burner cartridge (see fig. 8-11).
1
Place log B in the right rear positioning cam and place the front on the positioning cam of log A.
3
Log B should not make contact with the standing burner, leave a space of 1 cm.
1
Place log C at the back of the appliance, with the left side on the bottom and the right side on log B (see fig. 8-12).
1
Place log D in the right front of the appliance next to the lying burner, the rear of log D against the tube of the right
standing burner.
1
Fill the vermiculite plates with chips, spread the chips evenly. Keep the front side free from chips, so that no chips can get
under the glass pane when the glass pane is closed.
3
The vermiculite plates are provided with square holes, these holes ensure air supply. Do not place more than one layer of
chips over these holes.
1
Place log E over the left standing burner.
1
Place log F over the right standing burner.
1
Spread the glow material, if required, over the v-shaped burner and fix the glow material under the chips and/or the
wood set.
3
Keep the space around the ionisation and ignition free from glow material.
1
Spread the ash, if required, over the chips, prevent it from getting on the burners.
38p-0022
38P-0028 /1
38P-0608
38P-0609
8-7
8-9
8-8
8-10