If the main burner DOES continue to burn:
1
8. Switch off the appliance and clean the glass pane prior to commissioning, as described in the user manual.
1
9. Repeat the ignition procedure a few times and perform checks as described in section 10.3.2.
1
10. From now on the main burner should ignite smoothly and continue to burn.
1
11. Clean the glass pane after burning for the first time, as described in the user manual.
3
Wait 5 minutes before you re-ignite the appliance.
10.3.2 Procedure for igniting the main burner
3
- The spark plug should ignite the main burner(s) within a few seconds and without popping.
- The main burner(s) must smoothly transfer the flame to the entire burner without popping and continue to burn.
- If the appliance does not ignite after 2 restarts and enters hard lock-out, it may never be reset by disconnecting the
appliance from the power supply. If a restart is necessary after all: remove or open the glass pane and make sure the
gas is able to escape from the appliance. After this, make the appliance free from voltage for 10 sec. After these 10 sec,
the power supply may be reconnected.
Ignite the appliance in the same way as the first ignition, as indicated in section 10.3.1.
1
Check the function of the main burner starting from a cold condition.
1
If sparks are observed between the spark plugs, the main burner should burn within a few seconds.
3
If NO sparks are determined, it is NOT permitted to continue the procedure.
Consult the diagram with error messages (appendix 1: Malfunctions) if the ignition of the main burner does not meet the
above-mentioned requirements.
2
The flame picture and a good flame transfer can only be properly judged if the glass pane is installed or closed.
10.4 Flame picture
The flame picture can only really be assessed once the appliance has been burning several hours. Volatile components
from paint, materials, etc. that are vaporised during the first hours affect the flame picture.
1
Check that the flame picture is in order.
1
Consult the diagram with error messages (appendix 1: Malfunctions) if the flame picture is not correct.
I nst allation manual
4 1
Summary of Contents for 0063CT3681
