Dru 0063CT3681, Installation Manual

Page: 8 / 48

6. Preparation
6.1 Unpacking
Note the following items when removing the packaging:
1
Remove all packaging materials.
1
Remove all supplied components in, on and/or at the appliance.
1
Check the appliance and accessories for damages (during transport).
1
If necessary, contact your supplier.
1
Never install an appliance that is damaged!
1
Remove any screws that are used to fix the appliance to a platform or pallet.
3
The glass pane(s) is/are made of a ceramic material. Very small irregularities in the glass panes cannot be avoided, but are
within the required quality standards.
3
Keep plastic bags away from children.
Table 6-1 indicates which components should be available after removing the packaging.
1
Contact the supplier if you find that not all components have been supplied.
1
Packaging must be disposed of in accordance with the regulations.
I nst allation manual
8
6.2 Type of gas
The data plate indicates for which type of gas, gas pressure and for which country this appliance is intended.
The data plate can be found on the appliance or can be attached to a chain to which it should remain attached.
3
Check whether the appliance is suitable for the type of gas and the gas pressure used at the location.
6.2.1 Gas type conversion
In order to convert this appliance to a different type of gas, please contact DRU's service department and ask for
the possibilities. The conversion should be performed by a recognised gas installer.
6.3 Gas connection
Place a gas tap in the gas pipe in accordance with the applicable regulations. The gas connection on the gas control is
located next to the receiver (fig. 6-2 (G
in
)).
3
- Make sure there is no dirt in the gas pipes and connections.
- No soldering may take place at the flexible gas hose(s), as this could cause leaks.
The following requirements apply to the gas connection:
- Use a gas pipe with the correct dimensions, so that no pressure loss can occur.
- The gas tap must be approved (in the EU this will be the CE mark).
- You should always be able to reach the gas tap.
Table 6-1: Parts included with the delivery
Part
Installation manual
User manual
Wood set (including: chips, vermiculite and ash)
Glow material
Restrictor slide
Remote control
Mains cable
Spare self-tapping screws
Compression fitting 15 mm x G3/8”
Socket spanner 8 mm
Number
1x
1x
1x
1x
1x
1x
1x
1x
1x
1x