7/9
9. MAINTENANCE PROCEDURES
Ensure the pump is positing so that it can be verified easily.
Ensure you have necessary personal protective equipment to avoid any contact with the grease.
The pump undergoes severe factory testing therefore no maintenance is forecasted with the pump.
DropsA recommends the use of lubricants that are free of any impurities as well as a regular cleaning of the pump’s
components.
The pump is dismantled as follows:
1.
Before removing the reservoir is must be completely emptied of lubricant.
2.
Disconnect the air inlet connection.
3.
Disconnect all tubing on the pump.
4.
Loosen the screws on the lid, remove the reservoir
taking ABSOLUTE care of the spring inside the reservoir ( it may still be
under tension – if so remove more lubricant.)
5.
Remove the pump and any filters if fitted.
6.
Unscrew the plug on the pneumatic pump body,
be careful
of the load on the internal spring. At this point you can remove
the internal components of the pump body.
At this point all components are loose and allow the cleaning and verifying of each component possible.
All components must be clean with cleaning fluid and lubricated before re-assembly.
Periodically it is necessary to check:
CHECK
TOTAL NUMBER OF PUMP CYCLES
The lubrication status
100
Lubricant level
200
Clean refilling filter
400
Clean bottom of reservoir if deposits have formed.
600
The machine does not require any special equipment for any checking and/or maintenance activity, however the
recommendation is to use suitable equipment which is in a good condition (according to current regulation) in order to avoid
causing damage to persons or machine parts.
Make sure that the electric and hydraulic supply has been disconnected before carrying out any maintenance intervention.
10. DISPOSAL
In the course of machine maintenance, or if the machine is scrapped, do not dispose of polluting parts into the environment.
Refer to local regulations with regard to their correct disposal. When scrapping the machine the identification plate and any
other documents must be destroyed.
11. INFORMATION ABOUT ORDERING
PART NUMBER
FEATURES
3413050
Pneumatic pump R=50:1 Reservoir 2 Kg (4,4 lb)
3413060
Pneumatic pump R=50:1 Reservoir 0.5 Kg (4,4 lb)
3133936
Replacement gaskets Kit
3133390
Adjustable pump output kit
3413050 C
Preloaded pneumatic pump R=50:1 Reservoir 2 Kg (4,4 lb)
