5/9
6. UNPACKING AND INSTALLATION
6.1 UNPACKING
Once a suitable installation position has been identified, unpack the pump and prepare for installation. It is important to inspect
the pump to ensure that there has been no damage during transportation. The packaging material used does not require any
special disposal procedures. You should refer to you regional requirements.
6.2 PUMP INSTALLATION
Allow sufficient space for install with 150mm clear space around the perimeter of the pump.
Mount the pump Locopump
Serie2
at “eye level” to avoid any risk of postural problems.
Do not install the pump in dangerous environments such as explosive/flammable areas or in areas subject to high vibration.
Only use the fixing holes on the support bracket which are intended for n°2 holes for screws Ø10 mm (0,4 in.)(use a flat washer
with the screw ). For more details of the fixing holes please verify the dimensions shown on the drawing in chapter 12.
6.3 ELECTRICAL CONNECTIONS
Ensure the electrical connection of the low level is connected before using the pump. See below drawing for connection details.
A label of this drawing is also on the pump’s reservoir.
Supply voltage 24 V max.
6.4 PUMP OUTLET CONNECTION
The hydraulic connection of the pump is on the front face of the pump. It is a standard 1/4” BSP ( see drawing in chapter 12 ).
6.5 AIR CONNECTION ON PUMP
Use an 1/8” BSP connection fitting. It also possible to use DropsA’s nut an cone fittings as the seating is already available.
Remember to use a 3/2 valve that allows the air to vent to atmosphere and the internal spring within the pump to reset.
6.6 HOW TO ADJUST THE PUMP OUTPUT OR PRESSURE
This can be done by: Regulating pressure: the output pressure has a 50:1 ratio with the inlet pressure. Therefore this can be
regulated depending on the requirements of the system. (See chapter 4 for min and max pressures).
Regulating pump: as standard the pump has a fixed output. For special requirements you can convert the pump by installing the
kit 3133390 –
ordered separately to the pump
– the kit is shown below.
To use this kit , mount the o-ring ( A ) then tighten the fitting ( B ) with a 27mm spanner. Loosen the counter nut (C) with a 13
mm spanner to unblock the screw (D), use the appropriate screw driver to screw IN for less output or screw OUT for more
output. After adjustments have been made you must tighten the counter nut (C) to block any further movements.
N.B.:
After all connections have been made please ensure that they are safe and properly secured down.
WARNING:
The unit is only to be opened and repaired by specialist personnel.
