If any of these conditions exist,
DO NOT
use the
cylinder and contact
your healthcare provider for a
replacement cylinder.
STEP 1:
Examine the outside of the cylinder and regulator assembly for debris, oils
or grease and noticeable signs of
damage, dents or dings, corrosion, excessive
heat or fire damage, pressure leak or any other sign of damage
that
might
cause a
cylinder to be unacceptable or unsafe for use.
STEP 2:
Check the flow selector knob to be sure it rotates and stops at each
setting.
WARNING: Fire Hazard
WARNING:
Fire Hazard
Make sure the fill valve, if equipped, is clean and free of dirt, debris, oil or other contaminants.
•
•
If the needle remains in its position, there is no leak and the device is ready for use.
STEP
4:
Ensure that the unit is set to the "OFF" position.
However, if the contents indicator shows a continuous decrease in pressure, there is a leak in the system.
In this event, contact your Home Care Provider.
CAUTION
:
Do not use a tool.
CAUTION
:
This should be performed before each use.
STEP
1:
Close the valve on the oxygen cylinder
by turning the valve clockwise.
STEP
2:
Depressurize the conserver by inhaling several times using the nasal cannula.
The gauge indicator should drop to zero.
STEP
3:
Check that all screwed unions and tube connections are tight.
If necessary, tighten them
by hand.
STEP 5
:
Slowly open the valve on the oxygen cylinder by turning the valve counter clockwise until the needle in the gauge
indicator
no longer moves.
STEP 6
:
Close the cylinder valve again by turning the valve clockwise.
STEP
7
:
Observe the needle in the gauge indicator for approximately one minute.
INSPECTION BEFORE EACH USE:
CHECKING FOR LEAKS:
11
Summary of Contents for Bonsai OM-812CE
Page 21: ...Pneumatic Diagram Pneumatic Diagram depicts device in conserving selection 21...
Page 122: ......
Page 123: ......
