OPERATING INSTRUCTIONS:
To reduce the risk of rapid oxygen recompression and fire, open the
cylinder valve slowly and completely
so the
pressure gauge moves
slowly as it indicates the cylinder pressure.
WARNING: Fire Hazard
STEP
6
:
Properly
position
the cannula with
the nasal prongs facing upward and insert the prongs
into nose. Wrap the cannula tubing over the ears and position in front of body
STEP
4
:
Select the setting on the conserver to the appropriate delivery setting
STEP 8:
Remove the nasal cannula and turn the selector switch to the “OFF” position.
STEP 9:
When not in use, store in a clean, dry location.
STEP
2:
I
f a leak is present (see "Checking for Leaks" section on previous page), close the cylinder valve, check the seal
washer (gasket) and reinstall. If the leak persists, DO NOT USE THE EQUIPMENT. Contact your Home
Care Provider for repair or replacement.
STEP 5:
Ensure cannula is properly attached to the Bonsai.
(see Fig.
E.)
CAUTION:
To help prevent possible damage to the unit and to maintain its
cleanliness, keep the Bonsai in a carrying bag. Several bags are available for use with
different cylinder sizes and configurations: contact your Home Care provider for more
information about carry bags.
FIGURE
D
FIGURE
E
STEP
3
:
Check the oxygen pressure gauge to verify that the cylinder pressure is within the operating range.
(see example in Fig. D).
STEP
1:
Make sure that the
Bonsai is set to the “OFF” position before opening the cylinder valve.
The
Bonsai will now start to deliver oxygen. The amount of oxygen delivered per pulse is
determined by the setting.
A sound may be heard each time the unit delivers a pulse of oxygen.
Adequate saturation will be achieved because of the precise time in the breathing cycle
in which
the pulse of oxygen is delivered.
STEP 7:
When finished using the system, close the oxygen supply cylinder valve
by turning
the valve clockwise and continue breathing through the nasal cannula until no further
oxygen is detected
and the gauge reads “Refill”.
12
Summary of Contents for Bonsai OM-812CE
Page 21: ...Pneumatic Diagram Pneumatic Diagram depicts device in conserving selection 21...
Page 122: ......
Page 123: ......
