ASSEMBLY AND USE
WARNING: Fire Hazard
• Secure the cylinder in an upright position.
• Inspect the unit to ensure the seal washer (gasket) is in good working condition and attached to the inlet nozzle.
Attaching the
Bonsai
conserver to
the cylinder
FIGURE C
Connection
View of
the Bonsai
conserver
WARNING: Fire Hazard
• Make certain that your hands are free of oil, grease and other contaminants.
STEP 4:
While holding the unit in place, tighten the cylinder attachment
knob by turning clockwise [see Fig. B].
NOTE:
Tighten only by hand. The use of a tool to tighten the
knob may damage the unit.
FIGURE B
• Inspect the valve of the cylinder and the Bonsai to ensure they are free of contaminants and damage.
If any indication of damage or contamination is detected, DO NOT use the equipment and contact your
Home Care Provider.
SETUP:
WARNING:
Use ONLY a manufacturer-specified seal washer (gasket). An incorrect
seal
washer (gasket) may
not
be oxygen compatible or may cause an
oxygen
leak,
creating
an
increased
fire
risk.
DO
NOT use the
device if
the manufacturer-specified seal washer (gasket) is missing.
STEP 1:
Loosen the cylinder attachment knob.
STEP 2:
Lower the Bonsai conserver over any post-valve cylinder with the
alignment pins toward the holes on the cylinder neck [see Fig. B].
STEP 3:
Line up the two pins and the seal washer (gasket) with the
corresponding holes on the cylinder post valve.
NOTE:
The cylinder attachment knob should be aligned with
the indentation on the post valve.
STEP 5:
Attach a standard cannula (7 ft. [2.13 m] or less in length) to the oxygen supply outlet. See Figure E on pg. 12
for an illustration demonstrating the proper positioning of the nasal cannula.
10
Summary of Contents for Bonsai OM-812CE
Page 21: ...Pneumatic Diagram Pneumatic Diagram depicts device in conserving selection 21...
Page 122: ......
Page 123: ......
