6.
Locate two pushrods and adjustable clevises. Install a clevis onto each control horn at outermost hole. Make
sure to face the clamping screw on each clevis towards the wingtip for easier adjustment. As demonstrated
below, you may need to pry the clevis open using a larger flat-head screwdriver.
7.
Insert wire "U-Bend" side of each pushrod into outermost hole of servo arm as shown below.
8.
While deflecting elevon towards top wing surface as shown below, slide pushrod into clevis by rotating
elevon back to neutral position. You may have to loosen clamping screw slightly to allow clevis to slide
easily onto pushrod.
9.
Ensure that both clevises slide freely on each pushrod for the next adjustments. Loosen clevis screw if
necessary.
9.
Summary of Contents for r2106gf
Page 1: ......
Page 5: ......
Page 27: ...SLOPE SOARING FUNDAMENTALS Views from side and above 20...