FINE-TUNING THE WEASEL-TREK FOR OPTIMUM FLIGHT PERFORMANCE
►
It is well worth spending a little time verifying the proper balance and trim of your glider. Doing so will
ensure the Weasel-TREK is a pure joy to fly and reacts predictably to the varying air currents experienced
while slope soaring. We find it easiest to fine-tune the CG position on the slope in light to moderate lift. This
will make it easy to climb quickly to altitude for the "dive test" described below.
To fine-tune the CG position for optimum performance, first climb to safe altitude, and verify glider is
trimmed for straight and level flight. If necessary, make any trim adjustments until a fairly straight and level
hands-off glide is achieved). Proceed to put glider into 45° dive to increase airspeed. Allow glider to dive
"hands-off" and see which of the three scenarios holds true for your glider:
1.
Correct CG Position:
If properly balanced and trimmed for level flight, the Weasel-TREK will remain in a
straight 45° hands-off dive. Additionally, a well-balanced and trimmed aircraft will fly hands-off in a
straight and level glide for a good while. If instead your glider noses up or down as speed increases, this
is a sign that your CG position is off; read on if this is the case.
2.
Nose-Heavy (too forward CG):
If the glider noses up gradually as speed increases without any elevator
input, the aircraft is most likely nose-heavy.
Solution:
Remove a bit of nose-weight and add DOWN
elevator trim until the first scenario above is achieved.
3.
Tail-Heavy (too rearward CG):
If the glider increases steepness of dive at higher speed (i.e. "tucks
under"), then it is tail-heavy. A tail-heavy glider will be a chore to fly, constantly requiring elevator input
to maintain a smooth flight trajectory.
Solution:
Add nose-weight and UP elevator trim until the first
scenario above is achieved.
IMPORTANT NOTES
:
Make sure your transmitter's trim
steps are set to the absolute
minimum, since small flying wings
like the Weasel-TREK are very
sensitive to trim adjustments. Note
that not all transmitters have
adjustable trim steps.
In order to achieve trimmed flight,
you will have to adjust elevator
trim slightly each time you add or
remove balance weight to the
nose of the glider.
17.
Summary of Contents for r2106gf
Page 1: ......
Page 5: ......
Page 27: ...SLOPE SOARING FUNDAMENTALS Views from side and above 20...