Dream-Flight r2106gf, Flight Manual

Page: 14 / 28

WING AND TAIL INSTALLATION
Gather items below:

Wing Panels (Right/Left)

Completed Fuselage (with servos, battery, and receiver installed)

(2) Elevon pushrods

(2) Adjustable clevises with clamping screws

(2) Wing Clamp Screws (7mm-long x 2mm dia.)

Tail Fin
1. As shown on the right, flex foam elevons 45
degrees in each direction a few times to loosen
hinge action.
2. If hinges remain rather stiff after flexing, you can
enhance control response and reduce servo load by
making 25mm-long incisions along foam hinges using
a sharp hobby knife. As shown in the two pictures
below, use a strip of masking tape as a guide to
create even cuts. Alternate, leaving approximately
25mm of intact hinge material between incisions
(imagine a dashed line cut pattern as shown below-
right). Make sure to leave about 55mm of intact
hinge material at each end of control surface.
7.