Dream-Flight r2106gf, Flight Manual

Page: 12 / 28

FUSELAGE PREPARATION
Gather items below:

Fuselage with canopy

(2) Elevon servos ( Part DFFA009)

Receiver with Battery Extension Wire attached (Part DFFA013)

4.8V, 750mAh receiver battery (Part DFFA012)

(2) Servo mounting decals (45 x 70mm, Clear)

(2) Velcro strips
1. Carefully remove canopy by gripping it near wing and raising one
side.
2. The canopy uses three strong magnets for a secure attachment. To
minimize damage to the canopy when removing it repeatedly, make
a simple pull-tab from a strip of 3M Blenderm tape (or similar).
Simply cut a 4cm-long strip of tape and fold one end over on itself to
create a non-sticky pull tab. Approximately 2cm of adhesive should
remain exposed to be applied to the underside of the canopy as
shown.
2. As shown below, press servos into molded pockets and route wire
leads through provided cutouts and into receiver compartment. Servo
reference labels can be removed at this time.
3. Apply provided servo mounting decals over each servo as shown
below. Rub decal firmly in place.
5.