Draytek Vigor2133 Vac, User Manual

Page: 596 / 706

Vigor2133 Series User’s Guide 584
-u <mode> It means to enable bandwidth control for UDP.
0: disable
1: enable
Default is disable.
-p <ratio> It means to enable bandwidth limit ratio for UDP.
-t <mode> It means to enable/disable Outbound TCP ACK Prioritize.
0: disable
1: enable
-V Show all the settings.
-I <bandwith> Minimum available non-VoIP Inbound Bandwidth when VoIP is
detected (Kbps).
Default value: half of WAN inbound bandwidth.
-O <bandwidth> Minimum available non-VoIP Outbound Bandwidth when VoIP is
detected (Kbps).
Default value: half of WAN outbound bandwidth.
-v 0 It means Auto bandwidth adjustment. Adjust to minimum In/Out
bandwidth setting (or half QoS bandwidth).
-v 1 When VoIP detected, QoS In/Out bandwidth adjusted to minimum
values.
-D Set all to factory default (for all WANs).
[…] It means that you can type in several commands in one line.
E
E
x
x
a
a
m
m
p
p
l
l
e
e
> qos setup -m 3 -i 9500 -o 8500 -r 3:20 -u 1 -p 50 -t 1
WAN1 QOS mode is both
Wan 1 is XDSL model ,don,t need to set up
Wan 1 is XDSL model ,don,t need to set up
WAN1 class 3 ratio set to 20
WAN1 udp bandwidth control set to enable
WAN1 udp bandwidth limit ratio set to 50
WAN1 Outbound TCP ACK Prioritizel set to enable
QoS WAN1 set complete; restart QoS
>
T T e e l l n n e e t t C C o o m m m m a a n n d d : : q q o o s s c c l l a a s s s s
This command allows user to set QoS class.
S S y y n n t t a a x x
qos class -c [no] –[a|e|d] [no][-<command> <parameter> | ... ]
S
S
y
y
n
n
t
t
a
a
x
x
D
D
e
e
s
s
c
c
r
r
i
i
p
p
t
t
i
i
o
o
n
n
Parameter Description
[<command>
<parameter>|…] The available commands with parameters are listed below.
[…] means that you can type in several commands in one line.
-h Type it to display the usage of this command.
-c <no> Specify the inde number for the class.
Available value for <no> contains 1, 2 and 3. The default setting is