Draytek Vigor IPPBX 2820n, User Manual

Page: 13 / 378

VigorIPPBX 2820 Series User’s Guide 5
1
1
.
.
2
2
.
.
2
2
F
F
o
o
r
r
V
V
i
i
g
g
o
o
r
r
I
I
P
P
P
P
B
B
X
X
2
2
8
8
2
2
0
0
n
n
LED Status Explanation
Blinking The router is powered on and running normally. ACT (Activity)
Off The router is powered off.
On A USB device is connected and active. USB
Blinking The data is transmitting.
CSM On The profile of CSM (Content Security Management) for
IM/P2P application is enabled from
Firewall >>
General Setup . (Such profile is established under
CSM menu).
On
Wireless access point is ready. WLAN
Blinking
It will blink while wireless traffic goes through.
If ACT and WLAN LEDs blink simultaneously when
WPS is working, and it will return to normal condition
after two minutes. (You need to setup WPS within 2
minutes.)
On The router is ready to access Internet through DSL link. DSL
Blinking Slowly: The modem is ready.
Quickly: The connection is training.
On The WAN2 connection is ready. WAN 2
Blinking It will blink while transmitting data.
On A PSTN phone call comes (in and out). However, when
the phone call is disconnected, the LED will be off
about six seconds later. Line
Off There is no PSTN phone call.
On The phone connected to this port is off-hook.
Off The phone connected to this port is on-hook.
Phone
Blinking A phone call comes.
QoS On The QoS function is active.
LED on Connector
On ISDN-S0 (ISDN-NT) mode is active configured from
IP PBX>>PBX System>>Phone Settings and an
ISDN phone adapter is connected.
Blinking ISDN S0 (ISDN-NT) mode configured from IP
PBX>>PBX System>>Phone Settings
is
active and an
ISDN phone adapter is not connected.
Left LED
(Orange)
Off It means ISDN TE mode is active which is configured
from
IP PBX>>PBX System>>Phone Settings .
On A phone adapter with phone set has been connected
(ISDN-S0) or ISDN line has been connected
(ISDN-TE).
ISDN1/2
Right LED
(Green)
Blinking ISDN-S0 (ISDN-NT) mode, it means an ISDN phone is
off-hook or a phone call comes.
In ISDN-TE mode, it means data, fax or voice (phone
call) is transmitting.