15
9. ASSEMBLY
Note:
Remove the plug from the socket before
carrying out adjustment, servicing or maintenance.
9.1 SPARK DEFLECTORS & EYESHIELDS –
FIG.1:
– As also shown in section 9.7, using the plain slot
screwdriver end of the spanner
:
– Fit both the spark deflectors
to the wheel
guards using the supplied screws
and washers
.
– Fit each of the clear plastic eye shields
to the
brackets located on the spark deflectors, using the
locking nuts and screws provided.
– Select the required position and tighten all the fixings.
Note:
Do not over tighten the fixings holding the shield as this may cause it to crack. Never
attempt to use the bench grinder with the eyeshields cracked, missing or incorrectly
positioned. The eyeshield must remain between the user and abrasive wheel.
9.2 TOOL RESTS – FIG.2:
Fit both tool rests
to the brackets, located on each
of the wheel guards, using the bolts
and locking
nuts
provided.
Adjust them so there is approximately 1.5mm between
the grinding wheel face and the tool rest.
Note:
Ensure the tool rest sits over the guard securing
bolt.
9.3 BENCH MOUNTING YOUR GRINDER:
Securely bolt the bench grinder to a work bench or other secure surface through the two
points in the base (fixings are not supplied). Ensure there is enough clear space around the
grinder to accommodate large items which may be ground, i.e. garden tools, etc.
To reduce any vibration, mount the grinder on a vibration absorbsion mat, Draper Stock
No.30743.
FIG.1
FIG.2
