9
WORKING WITH ACCESSORIES
Changing forming stations K9-1-WR for single lock
seam.
Before working with the power seamer
K9-1(-WAD) make sure you read the
operation instructions as well as safety
indications.
Read all of the safety regulations and
instructions carefully.
Disconnect plug from socket before
machine adjustment, servicing and also
when not in use. Injury - Danger.
Sequence of assembling forming stations
◼
Loosen the allen screws, double lock
forming stations 1.3 and 1.4.
◼
Take both rolls off the shaft.
◼
Assemble single lock forming rolls 3 and 4
to the marked numbers at the side of the
seamer 3 and 4, turn the rolls until the pin
settles itself into the hole of the shaft.
◼
Changing to double lock seam again, follow
instructions reverse as mentioned above.
◼
Preparing the panels and the seamer read
chapter working with the Seamer.
Assembling forming stations to the shaft
Lay out panels one after one, fasten
clips, close the panel with the Seamer, or
single lock hand seamer K8, to achieve a
clean single or double lock seam.
... the Roof- and Wall Program of
Working Direction
