DR PRO MAX450, Safety & Operating Instructions Manual

Page: 32 / 52

32
DR ®
LEAF & LAWN VACUUM
Dumping
1. Shut down the Mower and Vacuum Engines and set the Mower Parking
Brake when you are at the Dump area.
2. Remove the Enclosure Sleeve from the Outlet Chute ( Figure 69 ).
3. Separate the left and right side Door Flaps by disconnecting the four Buckles
(
Figure 70 ).
4. Attach the top Buckles of the side Door Flaps to the Buckles at both sides of
the Enclosure (
Figure 71 ).
5. Separate the top and bottom Door Flaps by disconnecting the Buckle and
then pulling the bottom Door Flap down to release the Magnets (Figure 72).
Fold the bottom Door Flap under the Bed to attach the Magnets underneath.
The top Door Flap can be left hanging down.
6. Push and hold the Dump Switch towards “ DUMP ” to tip the Collector back
( Figure 73 ) until it reaches full travel or the bed hits the ground.
7. Drive the Mower forward with the collector open to move the Leaf System
away from the pile of debris and allow all debris to slide from the Bed.
8. Shake the Collector if necessary to loosen any debris that remains in the
bottom.
9. Push and hold the Dump Switch on “ FLAT ” to tip the Collector back to its flat
bed position.
10. Close the Top and Bottom Door Flaps with the magnetic seal and buckle.
11. Undo the Buckles at the sides, close the Left and Right Doors and secure with
all four Buckles.
•
Always shut off the tractor and engine vacuum and use caution when
dumping the collector load.
•
Never back up with the Collector in the dump position.
Never drive in reverse with the Collector in the dump position.
Enclosure Sleeve
Figure 69
Outlet
Chute
Buckles
Figure 70
Left
Side
Right
Side
Rear Side
Flaps
Figure 71
Buckle
Magnet
(5 Places)
Figure 72
Buckle
Figure 73
Controls