CONTACT US AT
www.DRpower.com
23
Replacing the Wheels
Tools needed:
•
9/16" Wrench or Socket
•
Wheel – Part Number 222321
1.
With the weight of the machine on the wheel, loosen (counterclockwise) the
Axle Bolt (
Figure 25
) with a 9/16" Wrench or Socket.
2.
Block the machine up off the ground so that the Wheel you are removing
spins freely, remove the Axle Bolt, Lock Washer, Flat Washer, and Outer
Bushing.
3.
Slide the Wheel from the Axle.
NOTE:
If the Inner Bushing should slip out when removing the Wheel, simply re-
insert it on the Step & Mow™ Axle Shaft.
4.
Replace the Wheel and hardware in the reverse order.
Debris Guard Replacement
The purpose for this section is to be sure the operator of the TOW-BEHIND DR
FIELD and BRUSH MOWER is aware of the potential unsafe condition of
operating the machine with a damaged Debris Guard.
•
Inspect the Debris Guard before each use and often during use. If you notice
damage to the Debris Guard, DO NOT continue to use your machine.
•
Consider a Debris Guard (
Figure 26
) damaged when a flap is missing or torn.
•
If your Debris Guard is damaged call us Toll-Free at 1-800-DR-OWNER (376-
9637) and we will ship a replacement at no cost to you.
•
If you have any questions, please call Toll-Free at 1-800-DR-OWNER (376-
9637). Our Technical Service Support Staff is available between 8:30 am and
5:00 pm Eastern Time, Monday through Saturday.
Battery Care
Proper care can extend the life of a Battery. Follow these recommendations to
ensure your Battery’s best performance and long life:
•
Do not allow the Battery charge to get too low. If the machine is not used,
charge the Battery every 4 – 6 weeks. Operate the Engine for at least 45
minutes to maintain proper Battery charge.
•
Store an unused Battery in a dry area that does not freeze.
When performing any adjustment or maintenance, you must first shut off the engine, wait five (5) minutes to allow parts to cool
and disconnect the spark plug wire(s), keeping it away from the spark plug(s).
Figure 25
Axle Bolt
Outer Bushing
Inner Bushing
Lock Washer
Flat Washer
•
When performing any adjustment or maintenance, you must first shut off the engine, wait five (5) minutes to allow parts to
cool and disconnect the spark plug wire(s), keeping it away from the spark plug(s).
•
Do not operate your TOW-BEHIND DR FIELD and BRUSH MOWER with a damaged debris guard. Failure to replace the
damaged debris guard can result in thrown objects hitting the operator, which can cause severe injury.
Debris Guard
Figure 26
Debris Guard
Figure 26
Summary of Contents for 13 HP Pro
Page 29: ...CONTACT US AT www DRpower com 29 Schematic Deck and Drive Assembly...
Page 31: ...CONTACT US AT www DRpower com 31 Schematic Wheels and Push Bar Assembly...
Page 33: ...CONTACT US AT www DRpower com 33 Tow Bar and Remote Control Panel Assembly...
