DR 13 HP Pro, Safety & Operating Instructions Manual

Page: 36 / 36

7 5 M E I G S R O A D , P . O . B O X 2 5 , V E R G E N N E S , V E R M O N T 0 5 4 9 1
©2009 Country Home Products, Inc. All rights reserved 222191A
Daily Checklist for the TOW-BEHIND DR FIELD and BRUSH MOWER
To help maintain your TOW-BEHIND DR FIELD and BRUSH MOWER for optimum performance, we recommend you follow this checklist
each time you use your machine.
[ ]
Check the engine oil and Gas Tank level.
[ ] Check that Engine is clean of debris.
[ ] Check the general condition of the Mower, e.g.; nuts, bolts, welds, etc.
[ ] Check Tire Pressure and wear.
[ ] Check the Frame for wear and damage.
[ ] Check the Blades and Spindle for tightness, nicks, cracks, wear or debris that has wrapped around.
[ ] Check that the Remote Control Panel is secure.
[ ] check the Debris Guard for wear or damage.
End of Season and Storage
NOTE: Please refer to the Engine Owner's Manual for Engine-specific procedures.
•
Change the Engine oil and Oil Filter and replace the Fuel Filter.
•
Remove the Spark Plug(s) and pour about 1 ounce of motor oil into the Cylinder hole. Replace the Plug(s) and crank the Engine over a
couple of times using the Electric Starter. This will coat the pistons and seat the valves to prevent moisture buildup.
•
Clean or replace the Air Filter(s).
•
Clean dirt and debris from the Cylinder Head Cooling Fins, Blower Housing, Debris Screen, and Muffler area of the Engine.
•
If your TOW-BEHIND DR FIELD and BRUSH MOWER will be idle for more than 30 days, we recommend using a gas stabilizer. This will
prevent sediment from gumming up the Carburetor. If there is dirt or moisture in the gas or tank, remove it by draining the tank.
Completely fill the tank with fresh, unleaded gas and add the appropriate amount of stabilizer or gasoline additive. Run the Engine for a
short time to allow the additive to circulate.
•
Remove any wrapped weeds from the Blades Carrier Housing. Clean grass and debris from the top and underneath the mower Deck
with a stiff brush.
•
Check the Blades for nicks and wear. Remove the Blades and sharpen them, or have them professionally sharpened if needed.
•
Touch-up all rusted or chipped paint surfaces. Sand them lightly before painting.
•
Be sure all nuts, bolts, and screws are securely fastened.
•
Inspect moving parts and the Blades’ Drive Belt for damage and wear; replace if necessary.
•
Store the Battery in a dry area that will not freeze. If you will not use the machine over a long period, charge the Battery every four to six
weeks.
•
If possible, store your TOW-BEHIND DR FIELD and BRUSH MOWER inside, but not near an open flame or spark such as found in a
water heater.
•
After the TOW-BEHIND DR FIELD and BRUSH
MOWER has cooled, cover the machine with a
suitable protective cover that does not retain
moisture. Do not use plastic as this material cannot
breathe; it also allows condensation to form, which
will cause your machine to rust.
When performing any adjustment or maintenance, you must first shut off the engine, wait five (5) minutes to allow parts to cool
and disconnect the spark plug wire(s), keeping it away from the spark plug(s).
When performing any adjustment or maintenance, you must first shut off the engine, wait five (5) minutes to allow parts to cool
and disconnect the spark plug wire(s), keeping it away from the spark plug(s).