DPS Telecom D-PK-NG224-12003, User Manual

Page: 45 / 80

41
User Analogs 10.9
The NetGuardian 224's two multi-purpose analog inputs measure continuous ranges of voltage or current. Analog
alarms are typically used to monitor battery voltage, charging current, temperature, humidity, wind speed, or other
continuously changing conditions. To configure a user analog, simply fill in your description, thresholds, and other
fields listed in the table below, then click
Save .
The Provisioning > User Analogs menu
User Analogs
Default monitoring to
gauge view
Checking this box sets the default view in the Monitor>User Analogs menu to the gauge
view.
Enab (Enable) Checking the box in the Enab column enables monitoring of the analog channel.
Description User-definable description for the analog channel
Rev
Checking the reverse button changes negative values to positive, and positive values to
negative.
Notifications
Check which notification device(s), 1 through 8, you want to send alarm notifications for
this analog input.
Details
Record Freq The frequency with which the NetGuardian will record the analog reading
Deadband
The additional qualifying value the NetGuardian requires above/below your alarm thresholds
in order to set an alarm.
Units The unit(s) of measurement reported by a connected analog input.
Low ref and High Ref The low and high values for scaling voltage to your display units.
MjU (Major Under)
MnU (Minor Under)
MnO (Minor Over)
MjO (Major Over)
Threshold settings that, when crossed, will prompt the NetGuardian to set an alarm.
Recorded values less than an under value or greater than an over value will cause alarms.
Post On
Select the threshold alarms to post. All thresholds, Major Only, Minor Only, Major Over
Only, Major Under Only.
Push to Talk: Enable Checking this box enables Push-to-Talk feature for this analog.
Discrete Input Assign the alarm point associated with this analog.
Qual. Time (ms)
Length of time, in milliseconds, that an alarm point must be set before before an analog
can post.
Analog Gauge Type
Select the type of analog gauge represented in the Monitor>User Analogs>Gauge View
menu