Pool Heat Pump _6
OPERATING THE POOL HEAT PUMP
The
DPL Swimming Pool Heat Pump
is designed for easy operation. The side panel contains a digital
temperature control readout. The Heat Pump is set to reach and then maintain the selected pool water temperature, as
long as the pool pump is running.
To start the unit:
> Press the button . In normal operating mode, the display indicates the water temperature in centigrade degrees.
To stop the heat pump, press the button.
To adjust the temperature to the desired value:
> Press the button until the red pilot light turns on.
> To adjust the water temperature, press the or buttons until the targeted temperature is displayed.
The available temperature range is between 18 °C and 35 °C.
> To return to normal operating mode, press the SET button again, for at least 5 seconds.
The pilot light turns on whenever the heat pump is in operation, which means that the ventilator(s) and the compressor
are functioning in order to heat the pool.
All models use a 5-minute time delay to prevent repeated tripping of the compressor's overload protection mechanism, which is
caused by attempting startup before system pressures are equalized. Any interruption will result in a 5-minute time delay.
The pilot light will blink during this 5-minute time delay.
To display the temperature in farenheit (°F) or celcius (°C), press the and buttons simultaneously
for 3 seconds to select the desired temperature scale.
Warning:
Prior to starting the heat pump, you must ensure that:
> There is electricity supplied to the heat pump.
> The filter pump is operating with a minimum water circulation of 22,5 gallon/min.
If these two conditions are not met, it will be the heat pump will not start. In such a case, the digital display thermometer
will be unusable.
TIP:
Setting the thermostat to its highest setting will not heat the water faster than setting it at the desired temperature.
A:
pilot light
B:
pilot light
C:
Digital display
D:
Button to set temperature at desired value
E:
Start/stop button
F:
Temperature adjustment buttons
A
B
D
C
E
F
Summary of Contents for 100 HPRA-410
Page 1: ...50HPRA 410 80 HPRA 410 100 HPRA 410 410 OWNER S MANUAL POOL HEAT PUMP MDPL 00001A A ENGLISH ...
Page 14: ...Pool Heat Pump _13 WIRING DIAGRAM 50HPRA 410 80HPRA 410 100HPRA 410 ...
Page 25: ...Pool Heat Pump _24 NOTES ...
Page 26: ...43 de l Alcazar Blainville Québec Canada J7B 1R4 www dplpool com ...
