Doyon FC18, Manual

Page: 22 / 60

A-19
INSTRUCTIONS TO REMOVE THE CONVEYOR AND CLEAN
THE OVEN FC2
NOTE: In order to remove the conveyor, it is necessary to be two people.
1- Place the oven main switch [A] to the position "OFF" (see drawing next pages).
2- Make sure that the oven has cooled down completely.
3- Disconnect the yellow plug of the conveyor motor [B] (unscrew the plug).
4- Remove the two crumb trays located under the conveyor [C].
5-Take out the screws which hold the two finishing plates on each side of the conveyor [D] and remove
the finishing plate. [E]
6- To take out the conveyor, it takes two people, one at each end. The person who is at the
opposite side of the gear motor of the conveyor raises it 1 inch (2 cm) and pushes it
towards the front. When the end of the conveyor is inside the oven, it is preferable that
the same two people place themselves on each side of the conveyor and continue to pull
with precaution to take out the conveyor completely.
7- To re-install the conveyor, repeat the instructions above in reverse.
REVERSE THE CONVEYOR
It is possible to reverse the conveyor. When you are ready to re-install, just enter it at the opposite
side of the oven.
A
B
D
E
6
6
C