3.2.2 Assemble the Antenna and Bracket
1. Assemble the Antenna Plate (MNT-22-1) to the Antenna
n
Carefully put the Panel Antenna face-down on a soft surface so that the cable connector is at
the bottom.
n
Point the bracket receiver part of the Antenna Plate (MNT-22-1) so that the toothed-surface
points to the right.
n
Align the four (4) holes as shown in the illustration above with the four (4) threaded inserts on
the back of the antenna.
n
Put a Flat Washer and Lock Washer over each hole.
n
Put a short Hex Cap Screw into each hole and tighten the screws.
2. Assemble the Pole/Wall Mount (MNT-22-3) to the Angle Bracket (MNT-22-2).
n
Align the two parts so that their toothed surfaces point to each other and the holes are aligned.
n
Put a Flat Washer and Lock Washer over the holes.
Installation Manual - Revision: 0 - DRAFT | Dover Fueling Solutions
19
