Rack Monitor 8800E/8801E
Document: Operation Manual
Date: 16-Jun-2011
Version: A.6
Page 30 of 35 H71343
Maintenance.
When servicing the Rack Monitor 8800E/8801E the following needs attention:
•
Before maintenance the full installation must be shut down/off before proceeding,
•
Maintenance must be performed by authorized personnel only,
•
All fasteners must be inspected periodically,
•
After maintenance is performed, the Rack Monitor 8800E/8801E must be tested before the next use,
•
Periodical inspection (every 6 months) for leakages (especially with heavy rainfall or wind),
•
Periodically maintenance is not required, but we recommend to check the internals at least once a year, by
tucking all the cables and if there is no corrosion,
•
Depending upon the condition of the inside the enclosure after inspection, it may be necessary to apply a
coating of corrosion inhibiting spray to the interior components,
•
During servicing loading and unloading of tank trucks is not allowed,
•
During maintenance (partial) disassembling could be necessary, the same risks and procedures apply as
during installation,
Check Points.
During maintenance the following items should be checked:
•
All earth cables should rigidly connected and free from corrosion,
•
If there is no moisture inside of the enclosure,
•
If the main seal is still intact and still soft and smooth,
•
If there is no corrosion on any part inside the enclosure,
•
Visual inspect all electronic components, with special attention for the voltage suppressors (also see trouble
shooting in Troubleshooting.
Caution
: When replacing the fuses, always make sure that you replace the fuse with original ones with an equal
stated value.
When maintenance has been performed, the following should be done before closing the Rack Monitor
8800E/8801E:
•
Replace the corrosion protector (should be done every 6 months),
•
Put grease on the main seal,
•
Make sure that all earth cables are connected,
•
Apply coating (if necessary) to the interior components,
Caution
: - Make sure, before closing the enclosure, that the cables do not get stuck between the door and the
bottom side of the enclosure.
- When tightening the bolts, apply the torque mentioned in the installation manual.
