Installation
The installation and programming of
the dispenser may only be carried out
by authorised and appropriately trained
service technicians assigned by your
Cafitesse system supplier.
The dispenser is designed for
installation indoors on a stable surface
such as a table or counter.
When setting up the dispenser,
ensure there is a clearance of
approximately 5 cm / 2 in between
the dispenser and the wall.
Protect the dispenser against frost,
rain and direct sunlight.
Protect the dispenser against
running water, splashes, spray or
steam, heat and heavy dust.
Warning:
The.dispenser.may.not.be.
cleaned.using.a.water.jet.and.
is.not.suitable.for.installation.
on.a.surface.where.a.water.
jet.may.be.used.in.the.vicinity.
(e.g..for.cleaning.purposes).
•
•
•
Ensure that there is sufficient space
around the dispenser for ventilation.
Keep the front and rear of the
dispenser accessible for cleaning
and servicing.
Connect the dispenser to the
drinking water supply in compliance
with local regulations.
Caution:
Only hose sets as per EN 61770
may be used to connect the
water supply.
Caution:
If you intend to use the dispenser
to deliver cold drinks, please
check the drinking water quality
according to local regulations
beforehand to ensure that you
obtain cold drinks that pose no
health risks.
Connect the dispenser according
to local regulations to a secured
electric circuit.
•
•
•
•
If you connect the dispenser to a plug
in the wall, then:
Use a grounded safety socket in
compliance with local regulations.
Ensure that the electric circuit is
protected by a residual current
device.
Ensure that the plug remains
accessible after installation.
Warning:
Never.touch.the.power.source.
or.plug.if.your.hands,.the.
power.cord.or.socket.are.wet.
If you connect the dispenser to a
permanently wired power source
(without mains plug), then ensure that
the electric circuit is equipped with a
circuit breaker with a contact gap of
minimum 3 mm / 0.12 in that controls
all poles.
•
•
•
6
2011 - 01
l.
2 SAFETY INSTRUCTIONS
