DOTWORKZ D2 COOLDOME, Product Instructions

Page: 17 / 31

16
Installing Camera Bracket
Sony RZ50N
1. Install the Sony RZ50N camera onto the
D2 Camera Bracket center hole with (1) .25"-
20 3/8" Long Bolt, (1) .25" Lock Washer, and
(1) .25" Washer that are included.
Required components (see component
checklist): Part # 1,4,5,6,7,8,& 12
4. Now slide the camera bracket with the
camera into place to line up with 4 screws
holes from the standoffs.
5. Use (4) #8-32 screws (Phillips head) to
secure the bracket into place.
Again, make sure the camera
bracket is facing the right direction.
This edge nests in arch at front of D2
This edge of the bracket faces back of the D2 enclosure
Tip: Insert (2) #8-32 screws in the front two
standoffs to provide a guide to slide the
camera bracket into. The last two corner
holes should line up and be secured last.
3. The 2.5" standoffs will be inserted on the
upper portion of the D2.
2. The Sony RZ50N camera requires a 2.5"
spacing for optimal fit and operation. Use (1)
1.5" standoffs and (1) 1" standoffs that are
provided to create a
2.5" standoff. You will
need to create 4 of these with the included
hardware.
1" 1.5"
Picture represents standoff location & orientation.
Height of standoffs will vary depending on camera used.
Picture represents camera bracket orientation & how it is
secured. Don’t’ forget to mount your camera to the D2
camera bracket based on instructions.