Dot Hill Systems AssuredSAN 4544, Setup Manual

Page: 26 / 100

26 Installing the enclosures
Installing an AMS
Refer to Figure 15 when orienting the AMS for insertion into the target drawer. If you are installing into the
left drawer or middle drawer, refer to the illustration on the left when performing this step-procedure. If you
are installing into the right drawer, refer to the illustration on the right when performing this step-procedure.
Figure 15 Orient the AMS for installation
1. Squeeze the latch release flanges together—so that the locking-nib will clear the sheet metal bay
wall—and insert the AMS into the target disk bay.
2. Verify that the AMS is firmly seated in place.
The installed disk drive module should now appear as shown in the sectioned cutaway views of the
respective drawers in Figure 16 .
Figure 16 Secure the AMS into the disk bay
Installing a disk module
IMPORTANT: Please review FDE considerations on page 27 before populating the Ultra48 Series
enclosure drawers.
Refer to Figure 17 when orienting the disk drive module for insertion into the target drawer. If you are
installing a disk drive module in the left drawer or middle drawer, refer to the illustration on the left when
performing the step-procedure. If you are installing a disk drive module in the right drawer, refer to the
illustration on the right when performing this step-procedure.
Align AMS for insertion into disk bay
Right drawer Left or middle drawer
Right drawer Left or middle drawer