Doro 850 colour, Manual

Page: 12 / 44

English
12 www.doro.com
English
www.doro.com 13
Operation
Hands free/monitor
In addition to normal handset mode you can select either monitor or hands free
mode.
In monitor mode the handset is used as normal with the handset next to your ear,
but allows everyone within the room to hear the caller.
With hands free mode you make a call then place the handset on a table or similar
hard surface, this allows everyone in the room to converse with the caller.
1.
Dial the required telephone number. Mistakes can be erased by pressing
Clear
.
2. Press
O
the telephone number will now be dialled. The earpiece volume can
be adjusted by pressing
v
/
V
.
3.
Press
O
again to select the monitor function. Hold the handset to your ear and
continue the conversation as normal.
4. Press
O
again to select the hands free function.
5.
When you have selected hands free mode place the handset on a hard flat
surface, e.g. a table.
6. Speak towards the microphone on the lower front edge of the handset
(maximum 1 metre away).
7.
You can adjust the speaker volume during a call by pressing
v
/
V
(1 - min, 6 - max).
8. Press
O
again to switch back to normal handset mode. The handset must
again be placed against your ear to continue the conversation.
9. Press
L
to terminate the call.
Please note!
In hands free mode it is only possible for one person at a time to talk. The switchover between
speaker and microphone is automatic and dependent on the sound level of the incoming call and
the microphone respectively. It is therefore essential that there are no loud noises, e.g. music, in the
immediate vicinity of the telephone, as this will disrupt the speaker function.
Paging
Pressing
j
on the base unit will activate the paging signal on the handset. This
function is used to help locate the handset or to page the person carrying the
handset. The signal will stop automatically after a while or if the
L
button on the
handset is pressed. The page can also be cancelled by pressing
j
on the base unit
again.