851-592 Rev. A
9
Dorner Mfg. Corp.
7400 Series End Drive Conveyors
Installation
Nose Bar Idler Tail
Typical Nose Bar Idler Tail Components
(Figure 15)
Figure 15
1. Slide the nose bar idler shaft hands
(Figure 16, item 1)
into the take up blocks
(Figure 16, item 2)
.
2. Attach the nose bar transfer post
(Figure 16, item 3)
to
the nose bar idler shaft hands.
Figure 16
3. Ensure that the nose bar pucks
(Figure 17, item 1)
are
in line with the conveyor frame
(Figure 17, item 2)
.
Figure 17
NOTE
Do not insert the pull pins on the tension end
of the conveyor until the belt has been
installed.
NOTE
Adjust the acorn nuts
(Figure 11, item 5)
on
the key stops
(Figure 11, item 4)
to raise or
lower the tip up tail assembly.
1
Nose bar idler tail assembly
2
Pull pin (x2)
3
Conveyor frame
1
2
3
NOTE
Do not insert the pull pins on the tension end
of the conveyor until the belt has been
installed.
2
1
3
2
1
1
8
0˚
