851-592 Rev. A
11
Dorner Mfg. Corp.
7400 Series End Drive Conveyors
Installation
5. Ensure that the nose bar pucks
(Figure 23, item 1)
are
in line with the conveyor frame
(Figure 23, item 2)
.
Figure 23
Lifter Installation
Typical Lifter Components
(Figure 24)
Figure 24
1. Slide the belt lift pivot bar
(Figure 25, item 1)
through
the designated holes in the frame.
Figure 25
2. Attach the lifter bars
(Figure 25, item 2)
to the belt lift
pivot bar
(Figure 25, item 1)
. Make sure the hooked
ends of the lifter bars are facing down when resting
against the frame.
3. Attach the lifter handle
(Figure 25, item 3)
to the belt
lift pivot rod.
Wear Strip Installation
Typical Wear Strip Components
(Figure 26)
Figure 26
1. Position the wear strips
(Figure 27, item 1)
on the
frame.
NOTE
Do not insert the pull pins on the tension end
of the conveyor until the belt has been
installed.
NOTE
Adjust the acorn nuts
(Figure 18, item 5)
on
the key stops
(Figure 18, item 4)
to raise or
lower the tip up tail assembly.
1
Belt lift pivot bar
2
Lifter bars
3
Belt lift handle
4
M8 - 1.25 x 16 mm hex head cap screw
2
1
1
8
0˚
3
4
1
2
1
Wear strip
3
2
1
1
