Dorner Mfg. Corp.
20
851-592 Rev. A
7400 Series End Drive Conveyors
Preventive Maintenance and Adjustment
Figure 55
2. Lower the oposite end of the return shaft
(Figure 55, item 1)
and slide it out of the frame.
3. Follow steps 1 – 2 in "Specialty Intralox 1100 Series
Belts: Replacing a Section of Belt" on page 19.
4. Remove the belt.
5. Replace the damaged or worn belt. Refer to “Belt
Installation” on page 12 and “Belt Return Installation”
page 13.
Specialty Intralox 1600 Series Belts
Replacing a Section of Belt
1. Lift up on the belt to gain access to the underside
2. Use a flat head screwdriver to raise the end of the belt
rod above the retention lip
Figure 56
3. Remove the bet rod by gripping the end with a set of
pliers and pulling
(Figure 57)
.
Figure 57
4. Remove the belt rods on both sides of the section of belt
being replaced.
5. Replace the old section with a new section of belt.
Replacing the Entire Belt
1. Remove the belt returns by pushing up on the return
shaft
(Figure 58, item 1)
and sliding it through the large
hole
(Figure 58, item 2)
in the frame.
Figure 58
2. Lower the opposite end of the return shaft
(Figure 58, item 1)
and slide it out of the frame.
3. Follow steps 1 – 2 in "Specialty Intralox 1600 Series
Belts: Replacing a Section of Belt" on page page 20.
4. Remove the belt.
5. Replace the damaged or worn belt. Refer to “Belt
Installation” on page 12 and “Belt Return Installation”
page 13.
1
2
CAUTION
DO NOT reuse belt rods that are damaged or
show signs of wear.
1
2
