Fixed and Adjustable Height Stands Set-up, Operation & Maintenance Manual
Dorner Mfg. Corp.
5
851-558 Rev. B
3
.
On the side opposite height sticker (P of Figure 3)
install one (1) hex nut (Q of Figure 4) into each inside
stand leg (K) t–slot.
Figure 4
Q
K
4
.
Attach crossmember (M of Figure 5) to stand leg (K)
with button screws (R). Do not tighten.
Figure 5
R
K
M
5
.
Repeat step 4 for opposite stand leg. Make sure to
locate the red warning area (P of Figure 3) on the
same ends of stand legs (K of Figure 5).
Ç
Failure to secure screws (R
of Figure 6) may cause
conveyor sections to drop
down causing severe injury.
TIGHTEN SCREWS (R)
AFTER ADJUSTMENT.
6
.
Upright stand and locate and space crossmember(s)
(M of Figure 6) evenly along stand leg (K). Tighten
crossmember button screws (R) to 150 in–lb (17
N–m).
Figure 6
R
M
K
7
.
On the end with red warning area (O of Figure 7)
install one (1) hex nut (Q) into each outside stand leg
(K) t–slot.
Figure 7
Q
K
O
Installation
