Fixed and Adjustable Height Stands Set-up, Operation & Maintenance Manual
851-558 Rev. B
12
Dorner Mfg. Corp.
Conveyor Angle Adjustment
Required Tools
D
6 mm Hex Key Wrench
Ç
Loosening stand height or
angle adjustment screws
may cause conveyor
sections to drop down,
causing severe injury.
SUPPORT CONVEYOR
SECTIONS PRIOR TO
LOOSENING STAND HEIGHT
OR ANGLE ADJUSTMENT
SCREWS.
NOTE:
To rotate stand top plate, screws (S of Figure
23) may need to be re-located to other t–slots (AE).
1
.
Loosen flange socket screws
(S of Figure 23) on both
sides of stand
.
Figure 23
S
AE
2
.
Adjust conveyor to desired angle.
Ç
Failure to secure screws (S
of Figure 23) may cause
conveyor sections to drop
down, causing severe injury.
TIGHTEN SCREWS (S)
AFTER ADJUSTMENT.
3
.
Secure flange socket screws (S
of Figure 23
) to 24
ft-lb (18 Nm).
4
.
If conveyor is equipped with diagonal bracing (AH of
Figure 24), socket screw (AI) must be loosened to
adjust conveyor angle. Secure screw to 100 in–lb (11
N–m) after adjustment.
Figure 24
AH
AI
Preventive Maintenance and Adjustment
