Fixed and Adjustable Height Stands Set-up, Operation & Maintenance Manual
851-558 Rev. B
10
Dorner Mfg. Corp.
Stand Height Adjustment
Height Adjustment for Fixed and Adjustable
Height Stands
Required Tools
D
6 mm Hex Key Wrench
Ç
Ç
Exposed moving parts can
cause severe injury.
LOCK OUT POWER before
removing guards or
performing maintenance.
Ç
Loosening stand height or
angle adjustment screws
may cause conveyor
sections to drop down,
causing severe injury.
SUPPORT CONVEYOR
SECTIONS PRIOR TO
LOOSENING STAND HEIGHT
OR ANGLE ADJUSTMENT
SCREWS.
1
.
Using a support (AB of Figure 21), raise conveyor
and stand off the floor.
Figure 21
AB
K
R
AC
2
.
Loosen button screws (R).
3
.
Raise or lower stand leg (K) to the required height.
Level stand from side to side using a level (AC).
Ç
Ç
Failure to secure screws (R
of Figure 21) may cause
conveyor sections to drop
down causing severe injury.
TIGHTEN SCREWS (R)
AFTER ADJUSTMENT.
4
.
Tighten button screws (R) to 150 in–lb (17 N–m).
5
.
Repeat steps 2 through 4 on opposite stand leg.
Preventive Maintenance and Adjustment
