Fixed and Adjustable Height Stands Set-up, Operation & Maintenance Manual
851-558 Rev. B
4
Dorner Mfg. Corp.
Ç
Supports marked with this
symbol must be anchored to
the floor. Supports not
anchored to floor will tip,
causing severe injury or
death.
SUPPORTS MUST BE
ANCHORED TO FLOOR.
DANGER
Ç
Ç
Exposed moving parts can
cause severe injury.
LOCK OUT POWER before
removing guards or
performing maintenance.
Recommended Installation Sequence (see
Table of Contents for page numbers)
D
Assemble stand(s), if required
D
Attach stand(s) to conveyor (see Conveyor Installa-
tion, Maintenance & Parts Manual)
D
Attach optional diagonal bracing (see Diagonal
Brace Kit Manual)
D
Adjust stand height and level (see Adjustment sec-
tion, page 10)
Assembly
Stands Shipped Partially Assembled
Required Tools
D
6 mm Hex Key Wrench
1
.
Typical components (Figure 2).
Typical Components
H
Boots/Foot Plate Assembly (2x)
I
Hardware Pack, Standard Stand
J
Conveyor Mounting Bracket(s)
(2 possible configurations)
K
Vertical Stand Legs (2x)
L
Hardware Pack, Crossmember
(quantity as required)
M
Crossmembers (quantity as required)
N
U–nuts (2x)
Figure 2
K
H
M
N
J
L
I
or
2
.
Open standard stand hardware pack (I of Figure 2).
NOTE:
Stand legs (K of Figure 3) are equipped with a
height sticker (P). Assemble stand legs with the sticker
on the outside and the red warning area (O) at the bot-
tom of the legs.
Shown assembled. See steps 7 and 8 for boot as-
sembly.
Figure 3
K
P
O
Installation
