Saflok RT/RT Plus Installation Guide
PK3720_T 04-19 15
4.4
Steps to attach the lever handle to the lock housing
*NOTE: the position of the key is very important
6. Right-handed Lever handle: Turn the key (L1) aproximately
100º clockwise so that it is in the vertical position and the
recess entry for key is in the top position. (See Fig. 6)
Fig. 6
Recess entry for key in the top position
(L1)
Left-handed lever handle: Turn the key (L1) approximately to
100º clockwise so that it is in the vertical position and the
recess entry for key is in the bottom position. (See Fig. 7)
Fig. 7
Recess entry for key in the bottom position
(L1)
CAUTION
WARNING
IMPORTANT
The key (L1) and the recess entry for key must be in the
positions shown in Figs 6 & 7 before placing the lever handle
on the housing or the lever and the override mechanism will
not work
Troubleshooting:
If you have assembled the lever and housing with the key
(L1) in the wrong position, the key (L1) will get stuck. To
remove the key (L1), turn it so that it is in the vertical po-
sition and insert a small flat screwdriver (M1) (see page
17) into the hole under the lever handle to push Lever
Catch (J1) in (Fig.2). Remove lever, remove key. If it is still
stuck, turn the key 90º clockwise to the horizontal posi-
tion and push the Lever Catch (J1) in again with the small
screwdriver (M1). Remove key (L1).
4.3
Preparing the lever handle and cylinder for
installation
3. Insert the cylinder (D1) without key (L1) into the lever han-
dle (A1) (see Fig.3)
Fig. 3
(D1)
(A1)
4. Put the cylinder plug (C1) into the lever (A1) (see Fig.4)
Fig. 4
(A1)
(C1)
5. Insert key (L1) into cylinder (D1). Hold plug (C1) in position.
(See Fig. 5).
Fig. 5
(L1)
CAUTION
WARNING
IMPORTANT
If the lever is not assembled with the key in the position
shown in Fig. 6 & Fig. 7, the inside mechanism of the lock
could be damaged if the lever is rotated and forced.
4 Installation of Mechanical Override Model
