122
MicroController Control System
Testing And Adjusting
How to use the PARAMETER CHANGE Menu
Flow Chart showing how to make Programme changes using Digital Console.
1. Opening HEADING.
2. Press ENTER to go into the MAIN MENU.
3. The Display will show : PARAMETER CHANGE.
4. Press ENTER to go into the Parameter Change facility.
5. The Display will show the first Parameter.
6. Press either ROLL UP and ROLL DOWN to display the next
parameter.
7. The names of the Parameters appear on the Display.
8. When the desired Parameter appears, the Display will show
a Level Number that will be between 0 and 9. Press either PARAM.
(Top Right) or SET(Bottom Right) buttons to change the Level value.
9. The Display will show the New Level.
10. When you are satisfied with the results of the changes
you have made, Press OUT.
11. The Display asks “ARE YOU SURE?”
12. Press ENTER to accept the changes, or Press OUT
if you do not wish to accept the changes and wish
to make further modifications to the parameters.
13. The Display will show : PARAMETER CHANGE
14. Press either ROLL UP and ROLL DOWN to display
other parameters or press OUT.
Activating Default Settings
All of the parameter values can be set to the factory defanlt settings by the follawing procedure.
1. Enter the “Quick Diagnostics” mode. (refer to P44)
2. Remove all switches to neutral (include accelerator) position to display “AO”.
3. Direction lever FWD NEUTRAL Pull & Redease the tilt lever
Direction lever FWD NEUTRAL Pull & Redease the tilt lever (A0 A3 A0 A6 A0; 2times)
4. And then “d” will be displayed on the instrument.
5. Key switch OFF.
KEYBOARD
MAIN MENU
PARAMETER CHANGE
ACCELER. DELAY
LEVEL = 4
RELEASE BRAKING
LEVEL = 5
RELEASE BRAKING
LEVEL = 6
ARE YOU SURE?
YES = ENTER NO = OUT
MAIN MENU
PARAMETER CHANGE
DISPLAY
H2 REG DHX.XX
48V 600A XXXXXX
Summary of Contents for B20S-3
Page 3: ......