Doosan 12/154, Operation & Maintenance Manual

Page: 34 / 108

30 OPERATING INSTRUCTIONS
12/154
J1939
SPN
J1939
FMI
CUMMINS
CODE
J1939 SPN DESCRIPTION J1939 FMI DESCRIPTION CUMMINS DESCRIPTION
629 12 111 Controller #1 Bad Intelligent Device or
Component Engine Control Module Critical Internal Failure
- Bad intelligent device or component
629 12 343 Controller #1 Bad Intelligent Device or
Component Engine Control Module Warning Internal
Hardware Failure - Bad intelligent device or
component
629 31 2661 Controller #1 Not Available or Condition
Exists At Least One Unacknowledged Most Severe
Fault - Condition Exists
629 31 2662 Controller #1 Not Available or Condition
Exists At Least One Unacknowledged Moderately
Severe Fault - Condition Exists
630 12 3697 Engine Control Module
Calibration Memory Bad Intelligent Device or
Component Engine Control Module Calibration Memory -
Bad intelligent device or component
633 31 2311 Engine Fuel Actuator 1 Control
Command Not Available or Condition
Exists Electronic Fuel Injection Control Valve Circuit -
Condition Exists
639 2 426 J1939 Network #1, Primary
Vehicle Network (previously
SAE J1939 Data Link) Data Erratic, Intermittent or
Incorrect J1939 Network #1 - Data erratic, intermittent or
incorrect
639 9 285 J1939 Network #1, Primary
Vehicle Network (previously
SAE J1939 Data Link) Abnormal Update Rate SAE J1939 Multiplexing PGN Timeout Error -
Abnormal update rate
639 9 427 J1939 Network #1, Primary
Vehicle Network (previously
SAE J1939 Data Link) Abnormal Update Rate SAE J1939 Datalink - Abnormal update rate
639 13 286 J1939 Network #1, Primary
Vehicle Network (previously
SAE J1939 Data Link) Out of Calibration SAE J1939 Multiplexing Configuration Error -
Out of Calibration
640 14 599 Engine External Protection
Input Special Instructions Auxiliary Commanded Dual Output Shutdown -
Special Instructions
641 7 2387 Engine Variable Geometry
Turbocharger Actuator #1 Mechanical System not
Responding or Out of
Adjustment VGT Actuator Driver Circuit (Motor) -
Mechanical system not responding or out of
adjustment
641 9 2636 Engine Variable Geometry
Turbocharger Actuator #1 Abnormal Update Rate VGT Actuator Driver Circuit - Abnormal update
rate
641 11 2198 Engine Variable Geometry
Turbocharger Actuator #1 Root Cause Not Known VGT Actuator Driver Circuit - Root Cause Not
Known
641 12 2634 Engine Variable Geometry
Turbocharger Actuator #1 Bad Intelligent Device or
Component VGT Actuator Controller - Bad intelligent
device or component
641 13 1898 Engine Variable Geometry
Turbocharger Actuator #1 Out of Calibration VGT Actuator Controller - Out of Calibration
641 13 2449 Engine Variable Geometry
Turbocharger Actuator #1 Out of Calibration VGT Actuator Controller - Out of Calibration
641 15 1962 Engine Variable Geometry
Turbocharger Actuator #1 Data Valid but Above Normal
Operating Range - Least
Severe Level VGT Actuator Driver Over Temperature
(Calculated) - Data Valid But Above Normal
Operating Range - Least Severe Level
641 31 2635 Engine Variable Geometry
Turbocharger Actuator #1 Not Available or Condition
Exists VGT Actuator Driver Circuit - Condition Exists
644 2 237 Engine External Speed
Command Input Data Erratic, Intermittent or
Incorrect External Speed Command Input (Multiple Unit
Synchronization) - Data erratic, intermittent or
incorrect
647 3 2377 Engine Fan Clutch 1 Output
Device Driver Voltage Above Normal, or
Shorted to High Source Fan Control Circuit - Voltage above normal, or
shorted to high source
647 4 245 Engine Fan Clutch 1 Output
Device Driver Voltage Below Normal, or
Shorted to Low Source Fan Control Circuit - Voltage below normal, or
shorted to low source