DOMUSA Fusion Hybrid Gas Condens, Installation And Operating Instructions Manual

Page: 52 / 76

Fusion Hybrid Gas Condens
Fusion Hybrid Gas Condens Fusion Hybrid Gas Condens
Fusion Hybrid Gas Condens
50
50 50
50
17.2 17.2 17.2 17.2 Ad Ad Ad Adjustment justment justment justment pro pro pro process cess cess cess
The CO
2
value should be adjusted as follows.
Make sure that the air intake pipe of the Make sure that the air intake pipe of the Make sure that the air intake pipe of the Make sure that the air intake pipe of the module module module module is fully closed and t is fully closed and t is fully closed and t is fully closed and that the sealing is hat the sealing is hat the sealing is hat the sealing is
ensured ensured ensured ensured during calibration. during calibration. during calibration. during calibration.
Make Make Make Make sure that a sure that a sure that a sure that all radiator valves are open during adju ll radiator valves are open during adju ll radiator valves are open during adju ll radiator valves are open during adjustment, or if necessary, the stment, or if necessary, the stment, or if necessary, the stment, or if necessary, the
calibration process will be interrupted if the calibration process will be interrupted if the calibration process will be interrupted if the calibration process will be interrupted if the module module module module reaches the maximum reaches the maximum reaches the maximum reaches the maximum
temperature limit.
temperature limit. temperature limit.
temperature limit.
Press the MODE
MODE MODE
MODE and RESET
RESET RESET
RESET buttons simultaneously until the circle is
completed.
After releasing the MODE MODE MODE MODE and RESET RESET RESET RESET buttons, press the button ( )
to adjust the heating temperature before 3 seconds have elapsed.
The letters Ma Ma Ma Ma----nu nu nu nu will appear on the display for approximately 60 s.
During this time, the module makes several ignitions.
Do not touch the module and do not change gas pressure during
this time.
Once the module stabilises, the P0 value "Minimum power" will
appear on the display.
Check the O
2
level and use the navigation buttons so that the O 2 22 2
level is adjusted to the rated values indicated in the table of
measurement values.
Press the button to adjust the heating temperature ( ) until the
circle is completed.
The P0 value is registered, and the module will change its position to
"Ignition power"
Once the module stabilises, the P1 value "Ignition power" appears on
the display.
Check the O
2
level and use the DHW temperature adjustment
buttons so that the O
2
22
2
level is adjusted to the rated values indicated
in the table of measurement values.
Press the button to adjust the heating temperature ( ) until the
circle is completed.
The P1 value is registered, and the module will change its position to
"maximum power"